Table of Contents
Advertisement
List of Functions
Submenu
Display
You can make settings related to the projector's display.
Menu Position: Select the position to display the menu on
the projected screen.
Message Position: Select the position to display the message
on the projected screen.
Messages: When set to Off, the following items will not be
displayed.
Item names when the Source, Color Mode, or Aspect is
changed, messages when no signal is being input, and
warnings such as High Temp Warning.
Display Background
when no image signal is available to Black, Blue, or
Logo.
Startup Screen
when projection starts.
Standby Confirmation: (This is unavailable when the
Remote Control Type is set to Simple.) If it is set to Off,
you can turn off the power simply by pressing the [t]
button once.
Air Filter Notice: You can set whether or not (On/Off) to
enable Air Filter Notice. When this is set to On and a clog
in the air filter is detected, the message is displayed on the
screen.
Screen: (This setting is unavailable when projecting images
from a computer over a network.) Set the aspect ratio and
position of the projected screen according to the type of
screen being used.
s "Screen Settings"
Panel Alignment: Correct color misalignments (red and
blue) in the screen.
s "Panel Alignment"
Color Uniformity: Adjusts the color tone balance for the
whole screen.
s "Color Uniformity"
OSD Rotation: Rotates the menu direction by 90 degrees.
Function
*2
: You can set the screen status for
*2
: Set to On to display the User's Logo
p.30
p.197
p.198
Submenu
User's Logo
*2
You can change the user's logo that is displayed as a
background during Display Background, A/V Mute, and so
on.
s "Saving a User's Logo"
Projection
Select from one of the following projection methods
depending on how the projector is installed.
Front, Front/Ceiling, Rear, and Rear/Ceiling
You can change the setting as follows by pressing down
the [A/V Mute] button for about five seconds.
FrontWFront/Ceiling
RearWRear/Ceiling
Set this parameter according to the installation status of the
Direction
projector.
*3
s "Installation Settings"
For portrait installation, set Portrait Mode to On.
141
Function
p.119
p.28
Advertisement
Table of Contents
