Inserting The Batteries; Connecting The Optional Power Adapter - Dymo LetraTag LT-100T User Manual

Inserting the Batteries

The labelmaker uses four high-capacity AA alkaline batteries.
To insert the batteries
1. Remove the battery compartment
cover. See Figure .
. Insert the batteries following the
polarity markings (+ and –).
. Replace the cover.
Ç
labelmaker will not be used for a long
period of time.

Connecting the Optional Power Adapter

An optional 9 Volt,1.5 A power adapter can also be used to power
the labelmaker. Connecting the AC adapter to the labelmaker
disconnects the batteries as a power source.
To connect the power adapter
1. Plug the power adapter into the power connector on the top of
the labelmaker.
. Plug the other end of the power adapter into a power outlet.

LT Momentum WEU.indd 4
Remove the batteries if the
Figure 2
09-01-2007 17:23:36