Table of Contents
Advertisement
Channel installation
This section describes how to install the TV channels
automatically.
1
Connect the RF signal to the TV.
2
Plug the power cord into the power outlet.
3
Turn the TV on.
46HFL3684S, 42HFL3684S
•
Press . (POWER) at the rear of the TV or use the
. (POWER) on the remote control.
Cable
7
39HFL3684S
•
Press . POWER at the front of the TV or use the
. (POWER) on the remote control.
4
Press RC5 SETUP to put the remote control into setup
mode, then press the HOME/MENU button to display
the setup menu. (Hereafter, HOME/MENU will be
simply referred to as MENU)
5
Select Consumer TV setup - Setup - Autoprogram ;
then select Cable. (unless the installation is using only
Antenna signals - in which case you would select
Antenna)
Note
•
The TV will not tune any channel that has not been fi rst
"installed". This includes SPI direct tune commands!
Advertisement
Table of Contents
