Samsung AC NN4SEC Series User & Installation Manual page 33

13. Setting SEG16, SEG17 option
Press Low Fan button(∨) to enter SEG16 value.
Press High Fan button(∧) to enter SEG17 value.
Each time you press the button,   ...  will be selected in rotation.
14. Advance to next "page"
Press Mode button to advance ("Dry", "Off" on display)
15. Setting SEG18, SEG20 option
Press Low Fan button(∨) to enter SEG18 value.
Press High Fan button(∧) to enter SEG20 value.
Each time you press the button,   ...  will be selected in rotation.
16. Advance to next "page"
Press Mode button to advance ("Fan", "Off" on display)
17. Setting SEG21, SEG22 option
Press Low Fan button(∨) to enter SEG21 value.
Press High Fan button(∧) to enter SEG22 value.
Each time you press the button,   ...  will be selected in rotation.
18. Advance to next "page"
Press Mode button to advance ("Heat", "Off" on display)
19. Setting SEG23, SEG24 mode
Press Low Fan button(∨) to enter SEG23 value.
Press High Fan button(∧) to enter SEG24 value.
Each time you press the button,   ...  will be selected in rotation.
Step 3. Check the option you have set
After setting option, press


Step 4. Input option
Press power button
NOTE
• When etering options this way, if you are only changing options after the system has been in operation, you mustgo
through all 20 option segments and set. If you do not, the controller will set unchaged segment to "0". For example,
if you only change SEG17 to "1" and input the options into the indoor unit, all other 19 segments will be set to "0".
Step 5. Check operation
1) Reset the indoor unit by pressing the RESET button of indoor unit or outdoor unit.
2) Take the batteries out of the remote controller and insert them again and then press the operation button.
Option setting
button to view each "page" to verify the option code you input is correct.
 
 
two times while pointing the remote control at the indoor unit.
Status
SEG16
SEG18
SEG21
SEG23
 

SEG17
SEG20
SEG22
SEG24
English 33