Oki ML5721 User Manual page 65

PROBLEM
Improper cut sheet feed
No paper feed.
Continuous forms instead of
cut sheets are fed.
Paper distortion.
Unable to eject.
Improper continuous forms feed.
No line feed, and no paper
feed.
Paper distortion or jam.
Several blank lines appear in
the printout.
The selected skip over
perforation spacing does not
match the physical tear-off
perforation positions.
Abnormal switchover between cut sheet and continuous forms modes.
No cut sheet feed.
No continuous forms feed.
CAUSE
Sheets are located off the
paper guide.
Sheets are not loaded to the
end.
The printer is in the
continuous forms mode.
Sheets are not loaded to the
end, or they are not inserted
straight.
Paper with wrinkles, folds or
other defects.
Paper not specified for the
printer.
The LF/FF button is pressed.
Paper is off the Pin Tractors.
The adjust lever position does
not match the paper type.
Forms are loaded with their
left holes out of line with the
right ones.
Inadequate distance between
the left and right Pin Tractors,
making for loose paper.
Skew paper feeding.
Paper movement is blocked.
Paper source is too far from
the printer.
Paper not specified for the
printer.
Skip over perforation spacing
is selected.
The paper length selected in
the application does not
match the physical paper
length.
The printer is in continuous
forms mode.
The printer is in cut sheet
mode.
Troubleshooting > 65
ACTION
Load sheets with their left
edges against the paper
guide.
Load sheets to the end.
Eject the continuous forms
and select cut sheet mode for
the printer.
Load sheets to the end.
Change paper.
Use paper types specified for
the printer.
Press the LOAD/EJECT
button.
Reload paper correctly.
Set the adjust lever to the
correct position.
Load forms with their left
holes in line with the right
ones.
Relocate the Pin Tractors to
tighten the paper.
Move the paper to make it
straight.
Remove the blockage.
Move the paper source n earer
to the printer.
Use paper types specified for
this printer.
Cancel the skip over
perforation spacing.
Match the paper length
selected in the application
with the physical paper
length in use.
Select the paper length in
number of lines in the
application.
Set the Paper Type lever to
cut sheet mode.
Set the Paper Type lever to
continuous forms mode.