Table of Contents
Advertisement
GROUP
ITEM
Set-up
Paper End
cont.
Detection
Print Registration
1
Print Registration
2
Print Registration
3
Print Registration
4
7 or 8 Bits Data
Word
Operator Panel
Function
Reset Inhibit
Print Suppress
Effective
Auto LF
Auto CR
(Displayed only for
IBM emulation)
FUNCTION
Select whether to detect
paper end or not.
Change to OFF to
override the sensor and
print closer to the
bottom of the page.
Adjust the print starting
position on printing in
the reverse direction.
(The position moves to
the right or left in 1/720
in increments.)
Adjust the print starting
position on printing in
the reverse direction.
(The position moves to
the right or left in 1/720
in increments.)
Adjust the print starting
position on printing in
the reverse direction.
(The position moves to
the right or left in 1/720
in increments.)
Adjust the print starting
position on printing in
the reverse direction.
(The position moves to
the right or left in 1/720
in increments.)
Select data word
lengths.
Select full or limited
operation.
Changing this to Yes
prevents a reset signal
from the computer from
resetting the printer to
its defaults.
Select whether to enable
or disable a print
suppress setup
command.
Select whether to
perform auto LF
operation or not upon
receiving a CR code. If
your print out is
consistently double
spaced, select No, if it
overprints, select Yes.
Select Yes to add a
carriage return when a
Line Feed is received at
the end of a line.
Operating instructions > 52
SETS
ML5720/ML5721
On
Off
-10 ~ -1
0
+10 ~ +1
-10 ~ -1
0
+10 ~ +1
-10 ~ -1
0
+10 ~ +1
-10 ~ -1
0
+10 ~ +1
7
8
Full Operation
Limited Operation
No
Yes
No
Yes
No
Yes
No
Yes
ML5790/ML5791
-
-
Advertisement
Table of Contents
