Table of Contents
Advertisement
2.3 Installation of Memory Modules (SO-DIMM)
IMB-140 motherboard provides two 204-pin DDR3 (Double Data Rate 3) SO-DIMM
slots.
1. It is not allowed to install a DDR or DDR2 memory module into a
DDR3 slot; otherwise, this motherboard and SO-DIMM may be
damaged.
2. Please install the memory module from DDR3_A2 slot for the first
priority.
Installing a SO-DIMM
Please make sure to disconnect the power supply before adding or
removing SO-DIMMs or the system components.
Step 1.
Unlock a SO-DIMM slot by pressing the retaining clips outward.
Step 2.
Align a SO-DIMM on the slot such that the notch on the SO-DIMM
matches the break on the slot.
The SO-DIMM only fits in one correct orientation. It will cause perma-
nent damage to the motherboard and the SO-DIMM if you force the SO-
DIMM into the slot in the incorrect orientation.
Step 3.
Firmly insert the SO-DIMM into the slot until the retaining clips at both
ends fully snap back in place and the SO-DIMM is properly seated.
12
Advertisement
Table of Contents
