Fujitsu AUXG12KVLA Design & Technical Manual page 366

¢ Description of display
(1) POWER/MODE
(2) ERROR
(3) MONITOR
Switch
• For the test run start and stop.
SW1 Push
• For the pump down start and stop.
• For when check run function is activated.
SW2 Push • For displaying the check run.
• For resetting the Automatic wiring correction memory.
SET1-1 DIP For selecting cooling or heating during test operation.
SET1-2 DIP For switching SW1 operation.
SET1-3 DIP (Prohibited)
SET1-4 DIP For outdoor unit low noise operation function.
SET2-1 DIP For selecting outdoor unit low noise operation function.
SET2-2 DIP (Prohibited)
SET2-3 DIP
Changing the current limit
SET2-4 DIP
Be sure to disconnect the power supply or turn off the breaker before changing the DIP switch
setting.
13-1. Setting methods
LED lamp
Green
Red
A Red
B Red
C Red
D Red
E Red
F Red
Function or operation method
Function or operation method
• Turns on when the power supply is ON (Including
when error occurs).
• Indicate the MODE by the number of flashes when
the installation function is active.
Flashes at high-speed when there is an error.
• Displays the location and contents of errors when
there is an error. (Refer to Chapter 14-3.
on page 367 for details.)
• Displays when check run is activated. (Refer to
Chapter 14-1. "Check run"
- 358 -
"Error code"
on page 360 for details.)
Factory setting
—
—
OFF
OFF
OFF (Do not change)
OFF
OFF
OFF (Do not change)
OFF
13. Function settings