Installation And Replacement Of Battery Pack - Omron HEM907KIT Instruction Manual

HEM-907-C3_D_M.fm Page 17 Wednesday, July 4, 2018 12:11 PM
How to Use the Power Source
Installation and Replacement of Battery Pack (option)
Warning
If the fluid in the battery gets into your eye,
wash the eye with sufficient water without
rubbing the eye, then immediately consult the
doctor for treatment.
• There is danger in losing your eyesight.
Do not use the exclusive battery pack (option)
other than for this unit.
Do not throw the battery pack into fire, or heat,
or disassemble it.
• It may cause heat, ignition, short-circuit, or
rupture.
1. Remove the two screws on the upper portion of
the cover of this unit, then remove the battery
cover.
2. Installation: Connect the battery pack to the
connector in the battery cover to install it.
Replacement: Disconnect the battery pack from
the connector and replace with a new one.
3. Install the battery cover and fasten it with
screws. At this time, be careful not to pinch the
lead wire.
4. Connect the main unit and the AC adapter, then charge the battery pack. The
battery pack is not charged when you purchase the monitor. When you use the
battery pack for the first time, charge it for more than twelve hours before use.
Battery life
• You can use the unit for approximately three hundred measurements with one charge.
• Approximate life of battery pack is two years. However the battery pack life from each charging
may be shortened depending on the state of using. If the interval between charging becomes
short and a mark appears frequently, replace it.
Charging time
• At approximately five seconds after connecting the AC adapter, the battery pack will start charging
automatically.
• While the battery is being charged, a
• The battery can be charged in approximately twelve hours.
Battery low
• Even after a
• If a mark is displayed, the battery is low (blood pressure cannot be measured.) Please
charge the battery.
Automatic Power Off
• If you use the unit with the battery pack, the unit will turn off automatically in approximately five
minutes even if you forget to turn off the power.
• While the AC adaptor is connected, the Auto Power Off function does not work.
17
mark turns on.
mark starts to blink, you can use the battery for twenty to thirty measurements.
However if the Battery Low Mark starts to blink, charge it soon.
Caution
Do not short-circuit the polarities of the
optional battery pack with a metal object such
as wire.
If the fluid in the battery is stained on your skin
or clothes, immediately wash off the fluid with
water.
• You may suffer injury, or the battery may
leak, heat, ignite fire, or explode.