Kenmore W10884766B Installation Instructions Manual page 15

3. Remove plastic cover from gas pressure regulator cap.
4. Turn gas pressure regulator cap counterclockwise with
a 5/8" (16 mm) combination wrench to remove.
NOTE: Do not remove the spring beneath the cap.
A
B
C
A. Plastic cover
B. Gas pressure regulator cap with solid end facing out
C. Gas pressure regulator cap with hollow end facing out
D. Washer
E. Gas pressure regulator cap
5. Turn over the gas pressure regulator cap and reinstall on
regulator so that the hollow end faces out and the marking
"ê LP" is facing the direction shown in the above drawing.
6. Replace plastic cover over gas pressure regulator cap.
To Convert Surface Burners (Natural Gas to
Propane Gas)
1. Remove burner cap.
2. Remove the burner base.
A
A. Igniter electrode
B. Burner cap
C. Gas tube opening
D. Burner base
3. Apply masking tape to the end of a 9/32" (7 mm) nut
driver to help hold the gas orifice spud in the nut driver
while changing it. Press nut driver down onto the gas orifice
spud and remove by turning it counterclockwise and lifting
out. Set gas orifice spud aside.
B
A
C
A. Igniter electrode
B. Orifice spud
C. Orifice spud holder
D. Screws
Side view before
D
E
Side view after
B
C
D
D
4. Remove the orifice spuds shipped in the literature package
in the oven. Gas orifice spuds are stamped with a number,
marked with one or two color dots, and have a groove in
the hex area. Replace the Natural gas orifice spud with the
correct Propane gas orifice spud.
A. Propane groove
Refer to the following chart for correct Propane gas orifice
spud ratings and to spud holder card for proper placement.
Propane Gas Orifice Spud Chart for Surface Burners
Burner Color
Rating/Type
15,000 BTU/ Silver
Stacked* Black/Orange
14,200 Silver
BTU/Ultra/
Stacked*
8,000 BTU/ Red/Orange
Semi
5,000 BTU/ Red/Blue
Auxi
1,200 BTU/ Black/Orange
Stacked/
Simmer*
* Not in all kits/models
NOTE: Refer to the model/serial/rating plate located on the
oven frame behind the top left-hand side of the oven door for
proper sizing of spuds for each burner location.
5. Place Natural gas orifice spuds in the orifice spud bag.
IMPORTANT: Keep the Natural gas orifice spuds in case
of reinstallation with Natural gas.
6. Replace the burner base.
7. Replace burner cap.
8. Repeat steps 1 through 7 for the remaining burners.
To Convert Oven Bake Burner (Natural Gas
to Propane Gas)
1. Remove the oven racks and the oven door. See the "Oven
Door" section.
2. Remove two screws and washers at the rear of the oven
bottom.
A
Size ID Placement
(mm) number
1.05 L105 LF
0.32 L32
1.05 L105 LF/RF
0.85 L85 RR/CTR
0.65 L65 LR
0.32 L32 LF
(Simmer)
15