Table of Contents
Advertisement
Faults and what to do about them
en
Information on the display
panel
Display
A:01
A:02
A:03
hot
¹
E:18
ªªª
LO kg, HI kg
Other displays
32
Cause/Remedy
Close the door immediately because of the rising water level. If an interruption
occurs, A:01 and OPEN are displayed alternately.
The door is locked for safety reasons (water level and/or temperature too high).
Washing programme: In pause mode A:02 and PAUS are displayed alter-
■
nately. If you have to open the door, wait until the temperature has dropped
slightly or pump out the water (select e.g. Spin 0 or Drain [).
Drying programme: If you have to open the door, wait until the temperature
■
has dropped slightly or set the drying programme to 15 min to cool down the
laundry.
If A:02 is frequently displayed at the end of the drying programme:
Clean the air filter. ~ Page 31
■
Run the Fluff Clean Ž (cold) programme without laundry.
■
Door cannot be locked/unlocked due to high temperature. Leave the washer
dryer switched on for about 1 min. The washer dryer can then be locked/
unlocked again.
The door cannot be opened after the drying programme due to the high tempera-
ture. The cooling process continues until the display disappears, after which the
door can be opened.
Flashes (no water supply): Tap turned on? Water inlet filter blocked? Clean
■
the water inlet filter. ~ Page 30
Water hose kinked or blocked?
Lights up (low water pressure): For information only. This will not affect the
■
programme progress. The programme duration is extended.
Drain pump blocked; clean the drain pump. Clean the drainage hose
on the siphon.
Hold down button Secar (Drying) for 3 seconds to delete the display.
■
Clean the air filter. ~ Page 31
■
Run the Fluff Clean Ž (cold) programme without laundry.
■
Laundry amount information. On when drying phase finished.
LO kg: Signals a small load for drying, HI kg: Signals a very high load for drying.
Turn the programme selector to Ú Stop. The appliance is switched off. Wait 5 s
and switch on again. If the display is indicated again, call customer service.
Advertisement
Table of Contents
