Hoshizaki SRK-15J Instruction Manual page 18

6) Slide the bin control assembly all the way back until the switch mount is flush with the
dispenser unit bin wall or the storage bin wall, top kit extension bracket, or brace. See
Fig. 11. Tighten the outer switch cover thumbscrews.
On dispenser unit applications, do not leave a gap between the bin control and the
wall of the dispenser unit bin wall. If a gap is left between the bin control and the
wall of the dispenser unit bin wall, ice may get between them and damage the bin
control.
7) Pull the bin control cable so that there is no slack in the ice drop area, then secure the
hose that the lead runs through with a cable tie. See Fig. 12.
8) Replace the water tank in the icemaker and reconnect the 4 hoses.
Note: Panels replaced during "II.I. Startup."
NOTICE
Switch Mount
Dispenser Unit: Slide the bin control
assembly all the way back until the switch
mount is flush with the dispenser unit bin
wall.
Storage Bin: Slide the bin control assembly
all the way back until the switch mount is
flush with the storage bin wall, extension
bracket, or brace.
Evaporator
Bin Control Cable
Cable Tie
Icemaker
Dispenser
Unit
To Control Box
Plastic Pipe
Hose
18
Fig. 11
Fig. 12