Table of Contents
Advertisement
Table 54 Port Forwarding: Add/Edit (continued)
LABEL
End Port
Translation Start
Port
Translation End
Port
Server IP
Address
Configure
Originating IP
Originating
IP
Protocol
OK
Cancel
11.3 The Applications Screen
This screen provides a summary of all NAT applications and their configuration. In addition, this screen
allows you to create new applications and/or remove existing ones.
To access this screen, click Network Setting > NAT > Applications. The following screen appears.
Figure 80 Network Setting > NAT > Applications
The following table describes the labels in this screen.
Table 55 Network Setting > NAT > Applications
LABEL
Add New
Application
Application
Forwarded
Chapter 11 Network Address Translation (NAT)
DESCRIPTION
Enter the last port of the original destination port range.
To forward only one port, enter the port number in the Start Port field above and then enter it
again in this field.
To forward a series of ports, enter the last port number in a series that begins with the port
number in the Start Port field above.
This shows the port number to which you want the VMG to translate the incoming port. For a
range of ports, enter the first number of the range to which you want the incoming ports
translated.
This shows the last port of the translated port range.
Enter the inside IP address of the virtual server here.
Select Enable to enter the source IP address of WAN interface.
Enter the source IP address of WAN interface.
Select the protocol supported by this virtual server. Choices are TCP, UDP, or TCP/UDP.
Click OK to save your changes.
Click Cancel to exit this screen without saving.
DESCRIPTION
Click this to add a new NAT application rule.
This field shows the type of application that the service forwards.
VMG3925-B10C/B30C User's Guide
175
Advertisement
Table of Contents
