Table of Contents
Advertisement
In this example, the DSL connection has the following information.
2
General
Name
Type
Connection Mode
Encapsulation
IPv6/IPv4 Mode
ATM PVC Configuration
VPI/VCI
Encapsulation Mode
Service Category
Account Information
PPP User Name
PPP Password
Static IP Address
Others
Select the Active check box. Enter the General and ATM PVC Configuration settings as provided above.
3
Set the Type to ADSL over ATM.
Choose the Encapsulation specified by your DSL service provider. For this example, the service provider
requires a username and password to establish Internet connection. Therefore, select PPPoE as the WAN
encapsulation type.
Set the IPv6/IPv4 Mode to IPv4 Only.
Enter the account information provided to you by your DSL service provider.
4
Configure this rule as your default Internet connection by selecting the Apply as Default Gateway check
5
box. Then select DNS as Static and enter the DNS server addresses provided to you, such as 192.168.5.2
(DNS server1)/192.168.5.1 (DNS server2).
Leave the rest of the fields to the default settings.
6
Click Apply to save your settings.
7
Chapter 4 Tutorials
MyDSLConnection
ADSL
Routing
PPPoE
IPv4
36/48
LLC/SNAP-Bridging
UBR without PCR
1234@DSL-Ex.com
ABCDEF!
192.168.1.32
PPPoE Passthrough: Disabled
NAT: Enabled
IGMP Multicast Proxy: Enabled
Apply as Default Gateway: Enabled
VLAN: Disabled
VMG3925-B10C/B30C User's Guide
36
Advertisement
Table of Contents
