LCD (Liquid Crystal Display) Module Removal
Prerequisite:
Speaker Module Removal
+
IMPORTANT:
3G is not available in this model.
1. Disconnect WLAN antenna cables (A) from WLAN module connectors, refer to
Module Removal
1. Remove WLAN antenna cables (A) from guides (B) on lower cover (Figure 3-56).
B
A
Figure 3-56. WLAN Module Cables
2. Disconnect 3G antenna cables (A) from 3G module connectors. Refer to
Removal.
3. Place computer face up.
4. Remove adhesive tape on cables as required.
5. Guide WLAN antenna cable through opening (H). Refer to
6. Guide 3G antenna cables through opening (G). Refer to
7. Remove four (4) screws (C) from LCD module hinges (Figure 3-57).
C
Figure 3-57. LCD Module Hinge Screws
Machine Maintenance Procedures
B
A
C
B
Figure
3-47.
Figure
3-47.
C
0
WLAN
B
3G Module
C
3-53