Table of Contents
Advertisement
3. Hardware Setup
Surface of
the cabinet
Figure 3.6. Installation of VESA metal fittings
CAUTION
-
If you tighten the screws with a tightening torque greater than that specified, the screw holes may
be damaged.
The appropriate tightening torque for the screws of the upper surface heat sink and side installation
metal fittings is 5 to 6 kgf•cm.
-
When the product is attached to the VESA attachment metal fittings, check the vibration resistance
and impact resistance of the display and the tightening torque of the screws before using the
product.
When a CONTEC FPD-H75XT-DC1 [weight: 3.6 kg, pitch: 75 mm] is attached, the vibration
resistance and impact resistance are the values shown below.
10 - 57Hz/semi-amplitude 0.075 mm, 57 - 150Hz/1.0G 40 min. each in x, y, and z directions
(JIS C0040-compliant, IEC 68-2-6-compliant)
10G, half-sine shock for 11 ms in x, y, and z directions
(JIS C0041-compliant, IEC 68-2-7-compliant)
18
BX-955Sx Series User's manual
Advertisement
Table of Contents
