Intercom - Panasonic KX-TGF572 Operating Instructions Manual

Intercom

Intercom calls can be made:
– between handsets
– between a handset and the base unit
Note:
R When paging unit(s), the paged unit(s)
beeps for 1 minute.
R If you receive an outside call while talking
on the intercom, the interrupt tone sounds
(page 46, 50).
– Handset: To finish intercom, press
MOFFN. To answer the call, press M
or MCELLN.
– Base unit: To finish intercom, press
MZN. To answer the call, press MZN
again or the corresponding cellular line
key (MCELL 1N or MCELL 2N).
R To change the handset ringer volume and
ringer tone for intercom, see page 46.
Making an intercom call
Handset
1
MMENUN a MbN: "Intercom" a
MSELECTN
2
MbN: Select the desired unit or "Voice
paging". a MSELECTN
R If you select "Voice paging", speak
into the microphone after the beep.
Your voice will be heard using the
speakers of the base unit and all
handsets, until a paged party answers
your page or until you press MOFFN.
After the other party answers, the
speakerphone mode is turned on.
3
When you finish talking, press MOFFN.
Note:
R You can also use the MINTERCOMN soft
key, if displayed, to make intercom calls.
R You cannot use voice paging if other units
are in use.
R Voice paging is not available when a range
extender (KX-TGA405) is registered to the
base unit.
For assistance, please visit http://shop.panasonic.com/support
Base unit
1
Press MINTERCOMN.
When 2 or more handsets are
registered:
– To page a specific handset, enter the
handset number.
– To page all handsets, press 0 or wait
for a few seconds.
2
When you finish talking, press MZN.
Answering an intercom call
N
Handset
1
Press M N to answer the page.
2
When you finish talking, press MOFFN.
Base unit
1
Press MZN to answer the page.
2
When you finish talking, press MZN.
Turning auto intercom on/off
This feature allows the handset or base unit to
answer intercom calls automatically when it is
called. You do not need to press M
MZN. When this feature is set to "On", the
monitoring handset or base unit for the baby
monitor feature (page 54) will also answer
baby monitor calls automatically. The default
setting is "Off".
Handset / Base unit
1
MMENUN#273
2
MbN: Select the desired setting. a
MSAVEN
3
Proceed with the operation for your unit
Handset: MOFFN
Base unit: MEXITN
Note:
R This feature is not available for all handsets
paging and voice paging even if it is turned
on.
Intercom
N or
33