Installation - Dometic RH440LGC Installation And Operating Manual

RH440, CL440, CL460
5

Installation

The cooling device is designed for free-standing installation, but can be built-in if the
following conditions are complied with to ensure satisfactory operation and maxi-
mum cooling efficiency.
• The cooling device must be levelled carefully to ensure proper function.
• The clearance between the cooling device's back and the wall should be 20 mm
or more.
• Ventilation must be provided as shown in alternatives A, B, C or D (fig. 2,
page 3).
• The ventilation duct must at least measure 105 mm x the width of the cooling
device.
• Only the entire cooling unit must project into the ventilation duct as shown
(fig. 2, page 3).
• Air passing through the ventilation duct must not be preheated by any source of
heat.
• Ventilation grills, if used, must have openings of at least 200 cm² each.
• For glass door version, when ambient humidity is above 65 % in 25 °C ambient
temperature, moisture will condense on the door.
• The cooling device can be fixed to the bottom of the furniture through its fixing
feets using screws of an appropriate length (fig. 3, page 3).
• The socket outlet for the mains connection must be freely accessible.
5.1 Changing the decorative plate
You can change the decorative plate: fig. 4 to fig. 7, page 4.
5.2 Mounting the sliding hinge (optional)
You can mount a sliding hinge that allows the cooling device door to be opened at
the same time as the door of the built-in cabinet: fig. 8, page 5, to fig. m, page 8.
5.3 Reversing the door
Reverse the door as follows: fig. n to fig. r, page 9.
Suitable for doors with sliding hinge only: fig. p to fig. q, page 9.
EN
Installation
15