Attaching The Embroidery Frame - Brother 888-L01 Operation Manual

Attaching the Embroidery Frame

Attaching the Embroidery Frame
Note
• Wind and insert the bobbin before attaching the
embroidery frame making sure to use the
recommended bobbin thread.
a Raise the presser foot lever to raise the presser foot.
b While lightly holding the lever on the frame holder to
the left, align the two pins on the embroidery frame
holder with the mounting brackets on the frame, and
then press the frame into the embroidery frame holder
until a click is heard.
Hold the lever lightly to the left.
a
1 Lever
Press the front mounting bracket onto the pin until it fits
into place.
1 Front mounting bracket
2 Front pin
Press the back mounting bracket onto the pin.
b
1 Back mounting bracket
2 Back pin
B-62
a
b
a
Note
• Be sure to completely insert both pins. If only
one of the pins is inserted, the pattern may not
turn out correctly.
• Make sure that the notch on the side of the
embroidery frame fits firmly under the bend in
the lever.
a
b
1 Notch on embroidery frame
2 Bend in lever
3 Carriage
4 Embroidery frame
Notch (1) fits firmly under the bend in the lever (2).
b b
c
a
Notch (1) does not fit firmly under the bend in the
lever (2).
a
c
b
1 Notch on embroidery frame
2 Bend in lever
3 Carriage
4 Embroidery frame
CAUTION
• Correctly set the embroidery frame into the
embroidery frame holder. Otherwise, the
presser foot may hit the embroidery frame,
resulting in injury.
c
d
d
d