Fcc, Acta And Ic Regulations - VTech CS5119-17 User Manual

FCC, ACTA and IC
regulations
FCC Part 15
NOTE: This equipment has been
tested and found to comply with the
requirements for a Class B digital
device under Part 15 of the Federal
Communications Commission (FCC)
rules. These requirements are intended
to provide reasonable protection against
harmful interference in a residential
installation. This equipment generates,
uses and can radiate radio frequency
energy and, if not installed and used
in accordance with the instructions,
may cause harmful interference to
radio communications. However, there
is no guarantee that interference will
not occur in a particular installation.
If this equipment does cause harmful
interference to radio or television
reception, which can be determined
by turning the equipment off and on,
the user is encouraged to try to correct
the interference by one or more of the
following measures:
• Reorient or relocate the receiving
antenna.
• Increase the separation between the
equipment and receiver.
• Connect the equipment into an outlet
on a circuit different from that to which
the receiver is connected.
• Consult the dealer or an experienced
radio/TV technician for help.
WARNING: Changes or modifications to
this equipment not expressly approved
by the party responsible for compliance
could void the user's authority to operate
the equipment.
This device complies with Part 15 of the
FCC rules. Operation is subject to the
following two conditions: (1) this device
may not cause harmful interference,
and (2) this device must accept
any interference received, including
interference that may cause undesired
operation. Privacy of communications
may not be ensured when using this
telephone.
To ensure safety of users, the FCC
has established criteria for the amount
of radio frequency energy that can be
safely absorbed by a user or bystander
according to the intended usage of the
product. This product has been tested
and found to comply with the FCC
criteria. The handset may be safely
held against the ear of the user. The
telephone base shall be installed and
used such that parts of the user's body
other than the hands are maintained at a
distance of approximately 20 cm
(8 inches) or more.
This Class B digital apparatus complies
with Canadian requirement:
CAN ICES-3 (B)/NMB-3(B).
FCC Part 68 and ACTA
This equipment complies with
Part 68 of the FCC rules and with
technical requirements adopted
by the Administrative Council for
Terminal Attachments (ACTA). The
label on the back or bottom of this
equipment contains, among other
things, a product identifier in the format
US:AAAEQ##TXXXX. This identifier
must be provided to your telephone
service provider upon request.
The plug and jack used to connect this
equipment to premises wiring and the
telephone network must comply with
applicable Part 68 rules and technical
requirements adopted by ACTA. A
compliant telephone cord and modular
28