Test And Adjustments - Capital PSQ24WK Installation Manual

TEST AND ADJUSTMENTS

STEP 7:
CAUTION:
For warranty coverage, Capital Cooking requires that burner adjustments be
made by a qualified technician at the the time of installation. Extreme care
should be used when adjustments are made after installation. Improper or lack of
adjustments will void your warranty.
SURFACE BURNERS
The surface burners are not adjustable. Proper operation is achieved when the correct orifices for gas
supply are installed at the factory, based on model ordered.
■ If the surface burner does not ignite, check the spark igniter by listening for a clicking sound. If you
do not hear the igniter click, turn off the burner. Check for a tripped circuit breaker, blown fuse, or
poor wire connection to the igniter.
■ If the gas igniter does not glow orange within 30-40 seconds or if the smell of gas is detected
without the presence of flames, turn off the burner immediately. Check for a tripped circuit breaker,
blown fuse, or poor wire connection to the igniter.
TO CLEAN EXTERIOR SURFACES
The stainless steel surfaces may be cleaned by wiping with a damp soapy cloth. Any mild glass cleaner
will remove fingerprints and smears. Do not use steel wool as it will scratch this surface. Small
scratches may be removed by lightly sanding with the gain using SCOTCH BRIGHT.
INDOOR UNITS ONLY
OUT DOOR UNITS ONLY
17