Table of Contents
Advertisement
Setup Tab
The Setup tab allows setting of the IP address, choosing means of communication (RS-232 or Ethernet), Vertical
Interval Switching mode, and Resetting the MatrixPRO.
To set the IP address, the MP Control GUI needs to be communicating with the MatrixPRO via RS-232. Once the IP
address is set then the GUI can be switched to Ethernet mode and communications conducted via Ethernet LAN
communication. Note that computer and the MatrixPRO need to have the 3 first numbers be the same.
There are 4 means of switching the video with the Video Switching Source menu. RGB Delay blanks the video, then
switches the syncs, then waits the amount of time indicated in the RGB Delay box in milliseconds then un-mutes the
video.
Selecting VREF In switches the video during the blanking period based on the Vsync feed into the VREF
input BNC. Channel 1 Sync switches the video during the blanking period based on Vsync input from channel 1.
Channel 1 Video switches the video based on the composite input video from Channel 1. If video into Channel 1 is
not composite and Channel 1 video is selected, unreliable results will occur.
Also the selection of VI source also determines the VREF output except if RGB Delay is selected.
The Reset MatrixPRO button clears all routing. Factory Reset MatrixPRO button erases all memory Presets, serial
settings, IP address, and routing.
Manual # 26-0301000-00 / Revision C
MatrixPRO 12x - 12 Input Matrix Switcher
19
Advertisement
Table of Contents
