Table of Contents
Advertisement
Software Upgrade Instructions
Overview
The MatrixPRO units built by Folsom Research, Inc. incorporate the system software in a Flash memory component.
Flash memory allows easy upgrades without the need to send the unit back to the factory due to software changes.
The loader utility provides the capability to update the system Flash module with the latest revision of software. The
upgrade utility can be run from a hard drive (recommended) or a floppy drive. Running the loader from a floppy drive
is discouraged though due to the slow speeds associated with disk access.
Hardware Requirements
* IBM compatible computer with an available COM port
* Serial cable conforming to EIA RS-232 specifications (i.e. Standard Modem cable)
(The cable should have a DB-9 male connector on one end)
Software Requirements
* Window 95/98/NT/2000/XP
* Flash File Loader
* MatrixPRO Software files
The Flash File Loader with the Software files can be downloaded from our FTP site as described below.
Connecting to Folsom Research
Folsom Research's FTP site address is: ftp.folsom.com
If you are using an FTP client, logon to our site using "anonymous" for the user name and your email address as the
password (ex. johndoe@somecompany.com).
If you are using a web browser to access our FTP site, point the browser to: ftp://ftp.folsom.com
Downloading Necessary Files
MatrixPRO Software Files and Flash File Loader
Directory Location: ftp.folsom.com\Products\Video\MatrixPRO\MP12x
File to download: "MatrixPRO12x_Rev#####_###.exe"
Installing the MatrixPRO Software Files and Flash File Loader
Before installing the files, it is recommended that all running programs be properly shut down.
1)
Click on the Start button and select Run.
2)
Click on the Browse button and locate the "MatrixPRO12x_Rev#####_###.exe" file on your hard drive.
3)
Double click on this file and then click OK to start the installation process.
4)
Follow the on screen instructions to complete the install.
Preparing to Upgrade the MatrixPRO 12x
1.
Plug the DB-25 male connector into the port labeled "RS-232/485 IN" on the back of the MatrixPRO unit.
2.
Make sure the other end of the cable is attached to the available COM port on the back of the computer
performing the upgrade.
3.
Turn the MatrixPRO ON or do a power cycle if it was previously powered on and wait for it to boot.
Starting the MatrixPRO Flash File Loader Utility
After the files have been installed the MatrixPRO Flash File Loader can be selected to run.
24
MatrixPRO 12x - 12 Input Matrix Switcher
Manual # 26-0301000-00 / Revision C
Advertisement
Table of Contents
