Setup And Adjustments; Changing The Sawblade; Maintenance And Inspection - Jet 10000808M Operating Instructions Manual

Fig 5
Tilt the table to the left until the
desired angle on the scale (G) has
been reached.
Retighten the locking knob.
Fig 6
Attention:
Angle cutting requires more care.
Be careful.

7. Setup and adjustments

General note:
Setup and adjustment work may
only be carried out after the
machine is protected against
accidental starting by pulling the
mains plug.

7.1 Changing the sawblade

The machine accepts pin blades and
plain end blades.
Check sawblade for flaws (cracks,
broken teeth, bending) before
installation. Do not use faulty
sawblades.
The sawblade teeth must point in
cutting direction (down)
The sawblades may only be
changed when the mains plug is
pulled!
Open the transparent sawguard.
Remove the table insert (M)
Release blade tension.
Fig 7
The quick release blade tension knob
(A) allows a quick and easy blade
change.
Fig 8
Loosen the upper and lower blade
holder screws (L and I).
Fig 9
Replace the sawblade.
The teeth of the blade must point in
the cutting direction (down).
The sawblade tension can be
adjusted by turning the tension knob.
6
Fig 10
Turn clockwise to increase tension
(Fig 10).
Reposition the table insert and the
transparent sawguard.

8. Maintenance and inspection

General notes:
Maintenance, cleaning and repair
work may only be carried out after
the machine is protected against
accidental starting by pulling the
mains plug.
Repair and maintenance work on the
electrical system may only be carried
out by a qualified electrician.
Clean the machine regularly.
Inspect the proper function of the dust
extraction daily.
All protective and safety devices must
be re-attached immediately after
completed cleaning, repair and
maintenance work.
Defective safety devices must be
replaced immediately.
Cleaning:
Regularly clean the machine housing
with a soft cloth preferably after each
use.
If the dirt does not come off use a soft
cloth moistened with soapy water.
Never use solvents such as petrol,
alcohol, ammoniac water, etc. These
solvents may damage the plastic
parts.
Saw blades:
Only use sharp saw blades.
Lubrication:
Lubricate the arm bearings after
every 50 hours of use.