Default Factory Settings
When you first receive your WGR614 v6, the default factory settings are shown below. You can
restore these defaults with the Factory Default Restore button on the rear panel. After you install
the WGR614 v6 router, use the procedures below to customize any of the settings to better meet
your networking needs.
Wireless Access Point
Wireless Access List (MAC Filtering)
SSID broadcast
11b/g RF Channel
Authentication Type
How to Set Up and Test Basic Wireless Connectivity
Note: If you use a wireless computer to configure WPA settings, you will be
disconnected when you click Apply. Reconfigure your wireless adapter to match the
new settings or access the wireless router from a wired computer to make any further
changes.
Follow the instructions below to set up and test basic wireless connectivity. Once you have
established basic wireless connectivity, you can enable security settings appropriate to your needs.
Log in to the WGR614 v6 firewall at its default LAN address of
1.
with its default user name of admin and default password of password, or using whatever
LAN address and password you have set up.
Wireless Configuration
Reference Manual for the 54 Mbps Wireless Router WGR614 v6
FEATURE
DEFAULT FACTORY SETTINGS
Enabled
All wireless stations allowed
Enabled
SSID
NETGEAR
11
Mode
g and b
Open System
WEP
Disabled
June 2004 202-10036-01
http://www.routerlogin.net
4-7