Front Glass Enclosure Panel, Removal And Installation; Install Vermiculite, Embers And Logs - Superior Fireplaces DRT35STDMN Installation And Operation Instruction Manual

Innovative Hearth Products
DRT35ST and DRT35PF Direct-Vent Gas Fireplaces
Front Glass Enclosure Panel, Removal
and Installation
WARNING
• Do not attempt to substitute the
materials used on these doors,
or replace cracked or broken
glass.
• Handle this glass with extreme
care! Glass is susceptible to
damage – Do not scratch or
handle roughly while reinstall-
ing the glass door frame.
• The glass door(s) of this appli-
ance must only be replaced as
a complete unit as provided
by the manufacturer. Do not
attempt to replace broken,
cracked or chipped glass sepa-
rately.
• Do not attempt to touch the
front enclosure glass with your
hands while the fireplace is in
use.
• DO NOT abuse glass door by
striking or slamming shut.
WARNING
The door should easily close
without needing to be pressed
down. If it has to be pressed
down to close, the gasket in the
top of the door should be dressed
so it lays on the glass.
WARNING
Do not operate appliance with
the glass front removed, cracked
or broken.
AVERTISSEMENT
Ne pas utiliser l'appareil si le
panneau frontal en verre n'est
pas en place, est craqué ou
brisé.
WARNING
Any safety screen, guard, or
barrier removed for servicing
an appliance must be replaced
prior to operating the appliance.
AVERTISSEMENT
Tout écran ou protecteur retiré
pour permettre l'entretien de
l'appareil doit être remis en
place avant de mettre l'appareil
en marche.
Only doors certified with the appliance
shall be used.
Seules des portes certifiées pour cet
appareil doivent être utilisées.
CAUTION: DO NOT abuse glass door by
striking or slamming shut.
These are direct-vent appliances. They are
designed to operate only when the front glass
enclosure panels are installed. Generally the
front glass enclosure panel should not be re-
moved except to gain access to the components
within the firebox.
To access the glass door securing latches, first
remove the hood by pulling firmly straight away
from the unit. Remove the front face assembly by
lifting up top and bottom evenly approximately
1/2" and pulling straight out from the unit once
the brackets are disengaged.
Remove the bottom compartment door by sliding
the hinge pin, located at the door's left side, to
the right until it disengages from the left corner
post hole. Pull the door diagonally to the left,
away from the fireplace. Locate the latch at the
top of the control compartment and disengage
them from the door frame bottom vee-flange,
pulling down on its handle to open it.
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
Installation and Operation Instructions
900300-00, 01/2018
Installing Glass Enclosure Panel
(see Figure 76)
Retrieve the glass door. Visually inspect the
gasket on the backside of the frame. Gasket
surface must be clean, free of irregularities
and seated firmly.
Position the door in front of the firebox opening
with the bottom of the door held away from the
fireplace (Figure 76). Hook the top flange of the
door frame over the top of the firebox frame.
Let the bottom of the door frame swing gently
in towards the fireplace ensuring that the gasket
seats evenly as the door frame draws shut.
Fasten the latch located underneath the firebox
floor to the door's vee-flange. Close both the
latch securely.
NOTE: Front Face Assembly with
barrier installed must be reinstalled
prior to operation.
Lower Compartment Door and Hinge
Top Flange
Glass Door Frame
Bottom Vee-flange
Glass Door Frame Firebox Floor
Glass Door Latch
Figure 76
INSTALL VERMICULITE, GLOWING EM-
BERS AND LOGS
NOTE: Turn off all electricity to the appliance
before you install vermiculite, embers and logs.
DO NOT attempt to install the logs until the
appliance installation has been completed, the
gas line connected and tested for leaks and the
initial burner operation has been checked out.
Glass Door
51