Install The Light; Attach The Emergency Release Rope And Handle - Chamberlain LiftMaster ATS 2113X Owner's Manual

INSTALLATION STEP 7

Install the Light

• Install a 75 watt maximum light bulb in the socket. The light
will turn ON and remain lit for approximately 4-1/2 minutes
when power is connected. Then the light will turn OFF.
• If the bulb burns out prematurely due to vibration, replace with
a "Garage Door Opener" bulb.
NOTE: Use only standard light bulbs. The use of short neck or
specialty light bulbs may overheat the endpanel or light socket.
INSTALLATION STEP 8

Attach the Emergency Release Rope and Handle

• Thread one end of the rope through the hole in the top of the
red handle so "NOTICE" reads right side up as shown. Secure
with an overhand knot at least 1" (2.54 cm) from the end of the
rope to prevent slipping.
• Thread the other end of the rope through the hole in the release
arm of the outer trolley.
• Adjust rope length so the handle is 6 feet (1.83 m) above the
floor. Secure with an overhand knot.
NOTE: If it is necessary to cut the rope, heat seal the cut end with a
match or lighter to prevent unraveling.
To prevent possible OVERHEATING of the endpanel or light
socket,
• DO NOT use short neck or specialty light bulbs.
• DO NOT use halogen bulbs. Use ONLY incandescent.
75 Watt Max.
Light Bulb
To prevent possible SERIOUS INJURY or DEATH from a falling
garage door:
• If possible, use emergency release handle to disengage
trolley ONLY when garage door is CLOSED. Weak or broken
springs or unbalanced door could result in an open door
falling rapidly and/or unexpectedly.
• NEVER use emergency release handle unless garage
doorway is clear of persons and obstructions.
• NEVER use handle to pull door open or closed. If rope knot
becomes untied, you could fall.
Trolley
Rope
13
Opener
Overhand
Knot
Trolley
Release Arm
Emergency
Release Handle