Programming; To Add Or Reprogram A Hand-Held Remote Control; To Erase All Codes; 3-Button Remotes - Chamberlain 3595C 3/4 HP Owner's Manual

PROGRAMMING

NOTICE: If this Security ✚
the receiver of the garage door opener, which provides security against code-theft devices, will be circumvented. The
owner of the copyright in the garage door opener does not authorize the purchaser or supplier of the non-rolling code
transmitter to circumvent that technical measure.
Your garage door opener has already been programmed at the factory to operate with your hand-held remote control.
The door will open and close when you press the large push button.
Below are instructions for programming your opener to operate with additional Security ✚

To Add or Reprogram a Hand-held Remote Control

USING THE "LEARN" BUTTON
1. Press and release the "LEARN"
button on the motor unit. The learn
indicator light will glow steadily for
30 seconds.
2. Within 30 seconds, press and hold
the button on the hand-held remote*
that you wish to operate your garage
door.
3. Release the button when the motor
unit lights blink. It has learned the
code. If light bulbs are not installed,
two clicks will be heard.
To Erase All Codes From
Motor Unit Memory
To deactivate any unwanted remote,
first erase all codes:
Press and hold the "learn" button on
motor unit until the learn indicator light
goes out (approximately 6 seconds).
All previous codes are now erased. Reprogram each
remote or keyless entry you wish to use.
® garage door opener is operated with a non-rolling code transmitter, the technical measure in
USING THE SMART CONTROL PANEL™
9 1 9 1
7 5 3 7 5 3
KG KG
1. Press the Prog <LEARN> button
on the Smart Control Panel™.
2. Press the Prog <LEARN> button
again to confirm LEARN Mode.
3. Press the button on the hand-held
remote that you wish to operate
your garage door.
4. When the motor unit lights blink, it
has learned the code. If light bulbs
are not installed, two clicks will be
heard.
If provided with your garage door opener, the large
button is factory programmed to operate it. Additional
buttons on any
Security✚ ® 3-button
remote or compact
remote can be
programmed to operate
other Security✚
door openers.
29
® remote controls.

*3-Button Remotes

® garage
T
L IG H
L O C K
T
L IG H
K
L O C