Napoleon PTSS165E Use And Care Manual page 15

Wall Mounting Instructions:
1. Using the two holes provided in the vertical tube, mount
the bracket to the wall.
2. Ensure minimum clearance to combustibles are
maintained, 4" (100mm) to sides, and 6"(150mm) from the
rear.
3. Do not locate the grill under unprotected combustible
construction.
4.The platform may be swivelled by removing the two #8 x 3/8" flathead
phillips screws and turning the platform to the desired angle. Replace the
two screws and tighten.
5. Once the platform is located in the desired position, the grill can be mounted:
a. Lock the lid of the grill closed with the latch.
b. Hold the grill by the handle with one hand, place the other hand under the grill in the centre of the
front tapered surface.
c. Place the grill bottom on the platform and slide it forward to engage the tab protruding from the
bottom of the grill. Ensure that the tab is properly engaged.
d. When the dimples on the bottom of the unit line up with the holes on the platform, the latch is ready
to be fastened.
Trailer Ball Mounting Instructions:
1. Place the ball mount over the ball on your drawbar or
bumper.
2.Tighten the two wing screws until the mount is firmly
held in place.
3. Once the mounting arm is tight, the grill can be
mounted:
a. Lock the lid of the grill closed with the latch.
b. Hold the grill by the handle with one hand, place the
other hand under the grill in the centre of the front tapered
surface.
c. Place the grill bottom on the platform and slide it forward to engage
the tab protruding from the bottom of the grill. Ensure that the tab is
properly engaged.
d. When the dimples on the bottom of the unit line up with the holes on the
platform, the latch is ready to be fastened.
4. Once the grill has been attached, thread the regulator (clockwise) into the
regulator mount. On tube burner version, lift the burner slightly to align it
with the orifice. Tighten by hand.
15