Before Use - Royal Tempo Operating Manual

3 Before use

2
3
A
4
5
230 - 240 V
50 Hz
Class II
230 - 240 V
50 Hz
Class II
6
12
11 13
10 14
9 15
8 16
7 5
6
7
3.1 Unpacking
3 Before use
1. Unpack the appliance and all its accessories.
2. Check the contents for completeness and possible damages. Scope of delivery see Z fig. 1.
ATTENTION:
Always transport or ship the appliance in its original packaging to avoid damage. Keep the packaging for
such an event.
Dispose of no longer needed packaging material properly.
NOTE:
Immediately contact your dealer if you have found damage resulting from transport.
3.2 Assembly
1. Push the brush base onto the connector of the upright cleaner (fig. 2). You must hear and feel the catch on
the backside of the connector (fig. 3/1) snap shut.
2. Select a place for the charging station where the appliance is stable and always protected from heat and
moisture during charging.
ATTENTION:
Never store the charging station or the appliance outdoors or next to heat sources (e.g. stoves or radiators).
Avoid exposing it to direct sunlight. Heat and moisture might damage the appliance.
3. Push the wall mount of the charging station (fig. 4/detail A) onto the connector of the base (fig. 4). You must
feel and hear it click into place.
NOTE:
Instead of pushing the wall mount onto the base, you may fix it to a wall. For attaching it to a wall, the wall
mount has 3 grommets on its backside (fig. 4/detail A).
ATTENTION:
Wall mounting only by adept do-it-yourselfers! Make sure that the wall you want to attach the wall mount to
is sufficiently firm and stable. Before drilling, make sure there are no electric or water lines in the area of the
wall where you want to drill. Also follow the instructions of the drill manufacturer.
3.3 Charging the batteries
WARNING:
Improper charging of the batteries can cause injury!
Use only the supplied charging station and AC adapter for charging the batteries. Never charge the batteries
with another charging station or AC adapter.
The battery must be charged before you can work with the appliance. To do this:
1. Connect the AC adapter to the connector of the charging station (fig. 5).
2. Connect the AC adapter to a socket that carries the same voltage as that indicated on the AC adapter's
type plate (fig. 6).
3. Make sure that the appliance is switched off and cannot be switched on by accident.
NOTE:
The appliance cannot be charged when switched on.
4. Set the upright cleaner with the grommet at its backside onto the charging station's receptacle (fig. 7). The
charging indicator will blink.
5. A complete charging cycle takes 14 to 16 hours.
NOTE:
The charging indicator is on continuously when the batteries are fully charged.
ATTENTION:
Take care to fully charge and then fully discharge the batteries. Incomplete charging and discharging cycles
can shorten battery life.
6. Remove the AC adapter from the socket when the charging indicator is on continuously. The battery is now
fully charged.
11