Ann-I/O Connection To Facp; Ann-I/O Module Led Wiring - Honeywell FIRE-LITE MS-10UD Series Manual

Installation

ANN-I/O Connection to FACP

The ANN-I/O connects to the FACP via the ANN-BUS as illustrated in Figure 2.25. After the ANN-I/O is connected to the panel, it must
be added to the system via FACP programming.
Primary ANN-BUS

ANN-I/O Module LED Wiring

There are four 12-pin connectors on the ANN-I/O module for connecting LEDs. Each set of 10 LEDs get their power from Pin 11 of the
corresponding connector. Internal resistors are sized so that there is approximately 10 mA of current for each LED. No series resistors
are required. LED outputs are mapped to output circuits. Refer to the section titled "ANN-I/O LED Zone Assignments" on page 72 of
this manual.
44
TB3
Figure 2.25 ANN-I/O Connection to FACP
ANN-I/O Module
ANN-BUS and power wiring are
supervised and power-limited
MS-5UD & MS-10UD Series Manual — P/N 52626:C7 6/12/2018
ANN-BUS Devices