Safety Information; Rfi Interference; Physical Characteristics; Housing - Fluke TS22A User Manual

TS22 Series Craft Test Sets
Users Guide

Safety Information

The following IEC symbols are used either on the test
set or in the manual:
W
Warning: Risk of personal injury. See the
manual for details.
Caution: Risk of damage or destruction to
equipment or software. See the manual
for details.
X
Warning: Risk of electric shock.
.
Earth ground
P
Conformité Européenne. Conforms to
relevant European Union directives.
~
Do not put products containing circuit
boards into the garbage. Dispose of
circuits boards in accordance with local
regulations.
WX
Do not use the test set if it is damaged.
Before you use the test set, inspect the case.
Look for cracks or missing plastic. Pay
particular attention to the insulation
surrounding the connectors.
If this product is used in a manner not
specified by the manufacturer, the
protection provided by the product may be
impaired.

RFI Interference

The TS22 Series Test Sets are designed to resist Radio
Frequency Interference (RFI). If RFI is encountered
during operation, take the following steps to minimize
the effects:
•
Reorient or relocate the line cord, the test set, or
both.
•
Increase separation between the source of the
interference and the test set.
2
Warning
•
Try connecting to another working pair.
The TS22 Series Test Sets are designed to resist Radio
Frequency Interference (RFI). If RFI is encountered
during the operation, take the following steps to
minimize the effects:
•
Reorient or relocate the line cord, the test set, or
both.
•
Increase separation between the source of the
interference and the test set.
•
Try connecting to another working pair.

Physical Characteristics

Housing

See Figure 1.
The housing for the TS22 Series Test Set is made of
high-impact polycarbonate which provides excellent
insulating properties. The test set is designed to
provide rugged service and withstand the rough
handling and shocks normally associated with craft
tools.
The back of the handgrip is contoured and has a non-
slip pad, freeing both hands while the test set rests on
the shoulder.

Belt Clip

See Figure 1.
The belt clip is located on the transmitter end of the
housing. It has a spring-loaded, locking clip that assures
a secure connection to belt loops and D-rings. The belt
clip may be replaced. See "Replacing the Belt Clip" on
page 10.