Table of Contents
Advertisement
11.7 LAMP REPLACEMENT
This appliance comes equipped with our "Crys-
talites™". If in the event the lamp needs to be re-
placed, follow these instructions.
Turn off all electrical supply.
A.
Remove the glass door and media tray
B.
from the fi rebox, see "DOOR REMOVAL /
INSTALLATION" and "BURNER REMOVAL"
section.
Unscrew the lens cover and lift the lamp
C.
straight out. Replace with Wolf Steel Ltd. parts
only (W387-0009).
D.
NOTE: Do not handle the lamp with bare
fi ngers, protect with a clean dry cloth.
Replace lens cover.
E.
Replace glass door and media tray.
F.
11.8 LENS ASSEMBLY REPLACEMENT
THE FRONT OF THE APPLIANCE BECOMES VERY HOT DURING OPERATION. LET THE APPLIANCE
Remove the glass and glass ember tray.
A.
Remove the burner base from the fi rebox.
B.
Compress the retainer fi ns and lift out the lens assembly. Disconnect the
C.
wires.
Replace lens assembly by aligning key hole and snap into place. Re-connect
D.
the wires.
Re-install burner base ensuring a good fi rebox seal.
E.
Re-install glass ember tray and glass.
F.
NOTE: When removing the glass ember tray make sure the glass embers are away from the center of
the screen, exposing the burner, before lifting glass ember tray out.
When replacing burner, absolutely no glass embers can be in cup surrounding the orifi ce. HINT: If glass falls
into cup and surrounds the orifi ce, insert a clean bag into a vacuum cleaner and vacuum out glass
embers. Replacement glass embers can be ordered from Wolf Steel Ltd.
!
COOL COMPLETELY BEFORE CONDUCTING SERVICE.
WARNING
C R
Y S
T A
L I T
E S
T M
KEY HOLE
W415-0839 / C / 02.03.12
53
Advertisement
Table of Contents
