Wireless N450 Home Router
5.2 Client Filter
To better manage devices in the LAN, you can allow or disallow the devices to access certain ports on the
Internet using the Client Filter function.
● Filter Mode: Select Deny or Allow.
● Select: Select an ID for the current entry.
● Description: Briefly describe the current entry.
● Start IP: Enter a starting IP address.
● End IP: Enter an ending IP address.
● Port: Enter TCP/UDP protocol port number, it can be a single port or a range of ports.
● Traffic Type: Select a protocol or protocols for the traffic (TCP/UDP/Both).
● Time: Specify a time range for current entry to take effect.
● Day: select a day or several days for current entry to take effect.
● Enable: Check to enable or uncheck to disable a corresponding filter rule (allow/disallow matched
addresses to pass through router).
Example: To prohibit PCs within the IP address range of 192.168.0.100‐‐192.168.0.150 from accessing the
Internet, use the following example:
51