Chapter 8 Security Settings; Client Filter Settings - Tenda W308R User Manual

8.1 Client Filter Settings

You can enable client filter to control LAN computers' access to some ports of the
Internet。

Filter Mode: You can select either "Permit only" or "Forbid only".

Access Policy: Select one number from the drop-down list.

Remark: A simple description of the configured file. You can also leave it blank.

Start/End IP: Enter the start/end IP address.

Port: Enter the controlled TCP/UDP protocol port. You can specify a port or port
range.

Type: Select one protocol (TCP/UDP/Both) from the drop-down list.

Time: Select the time range of client filter.

Date: Select the day(s) to run the access policy.

Enable: To enable/disable the access policy (forbid/permit the packets matched
with the access policy to pass through the router.
Example1 Forbid LAN computers at the IP addresses of 192.168.0.100--192.168.0.120
to access the Internet.
11N Wireless Broadband Router User Guide

Chapter 8 Security Settings

40