●
Enable WPS: Select to enable/disable the WPS encryption.
●
WPS Mode: Select PBC (Push‐Button Configuration) or PIN.
●
Reset OOB: When selected, the WPS LED turns off and the WPS function will be disabled automatically.
The WPS server on the router enters idle mode and will not respond to any client's WPS connection
request.
Operation Instructions:
PBC: The WPS LED will blink for 2 minutes after you press the hardware WPS button on the router for 1
second, and means that the PBC encryption method is successfully enabled. An authentication routine will
be performed between your router and the WPS/PBC enabled wireless client device during this time, if it
succeeds, the wireless client device will connect to your router and the WPS LED will turn off. Repeat the
steps above if you want to add more wireless client devices to the router.
PIN: To use this option, you must know the PIN code from the wireless client and enter it in the
corresponding field on your router while using the same PIN code on the client side for this connection.
Note
To use the WPS encryption, the wireless adapter must be WPS‐capable.
3.8 Connection Status
This section displays wireless clients information (if any).
41
Wireless N450 Home Router