Table of Contents
Advertisement
PW-AN401/PW-AN401D
Note:
To apply any settings you have altered on the page, please click the Save button, and then you
will be reminded to reboot the device.
You are suggested to implement Multi-SSID function with a switch that supports Tag VLAN feature.
Here is an example of how to configure Multi-SSID. Please take the following steps:
a)
Configure the Access Point
Select Multi-SSID as the operation mode of PW-AN401/PW-AN401D.
Select the checkbox before Enable VLAN to enable VLAN function for this access point.
Configure the SSID and its corresponding VLAN ID. The detailed parameters are shown as
the above figure.
STA1, STA2, STA3 and STA4 join to the wireless network with SSID1, SSID2, SSID3 and
SSID4 respectively.
Click Save to apply the current security settings for the selected SSID.
Note:
1.
The wireless STAs join to the network with different VLAN IDs cannot communicate with each
other, for example, STA1 and STA2.
2.
The wireless STAs join to the network with the same VLAN ID can communicate with each
other, for example, STA1 and STA3.
3.
All wireless STAs can log on to the Web management page of PW-AN401/PW-AN401D and
manage the access point, for example, STA1, STA2, STA3 and STA4.
150M Wireless N Access Point User Guide
Configure the Access Point
34
Advertisement
Table of Contents
