Video - Yamaha RX-A2080BL Owner's Manual

Video

Problem
No video.
No video from the playback device (connected to the
unit with HDMI).
The menu of the unit is not displayed on the TV.
The video is interrupted.
Cause
Another input source is selected on the unit.
Another input source is selected on the TV.
The video signal output from the unit is not supported by the TV.
The cable connecting the unit and TV (or playback device) is defective.
The input video signal (resolution) is not supported by the unit.
The TV does not support HDCP (High-bandwidth Digital Content
Protection).
The number of devices connected to the HDMI OUT jack is over the limit. Disconnect some of the HDMI devices.
Another input source is selected on the TV.
(If you are using 2 TVs in the main zone)
Another TV is turned off when "HDMI OUT 1+2" is selected.
HDMI audio output may be interrupted during some zone operations due
to internal circuitry switching.
En
Select an appropriate input source with the input selection keys.
Switch the TV input to display the video from the unit.
Set "MONITOR CHECK" in the "ADVANCED SETUP" menu to "YES" (p.160).
If there is no problem with the connection, replace with another cable.
To check the information about the current video signal (resolution), use "Video/HDMI"
in the "Setup" menu (p.143). For information about video signals supported by the unit,
see "HDMI signal compatibility" (p.186).
Refer to the instruction manuals for the TV and check the TV's specifications.
If you want to play back contents that require HDCP 2.2/2.3-compatible devices, both the
TV and playback device must support HDCP 2.2/2.3.
Switch the TV input to display the video from the unit (HDMI OUT jack).
Select "HDMI OUT 1" or "HDMI OUT 2" to output the signals only to the TV you are using
(p.74).
For details, see "Connecting an HDMI-compatible device to play back videos/audio"
(p.112).
172
Remedy