Selecting Voices From A Voice Disk (Optional) - Yamaha Electone EL-500 Owner's Manual

5
Selecting Voices from a Voice Disk
(Optional)
You can also load voices from optional Voice Disks to the 16 User voices
in the Voice Menu.
To do this:
1
Hold down the VOICE EDIT button in the DISPLAY SELECT section
and simultaneously press any one of the panel voice buttons.
2
Select the VOICE DISK page with the Page buttons.
The message "Insert Voice Disk!!" appears and prompts you the
operation.
2
Insert the Voice Disk into the disk slot under the Music Disk
Recorder.
The voice number and name of the Voice Disk appears.
VOICE DISK Page
4
Using any of the Data Control button pairs, select the voice you wish
to load.
5
Play the keyboard to check the sound of the voice. Select other
voices (as you did in step #4 above) and check those sounds as well.
6
If you want to save the current voice to a User Voice space, select
the previous page, "SAVE" with the Page buttons.
7
Press the Data Control button that corresponds to the User Voice
number you wish to save to.
Press one of the four Data Control buttons below [Save] in the
display to save the voice, or one of the four buttons below [Cancel]
to abort the operation and return to the previous display.
When the voice has been saved, a "completed!!" message appears.
The EL-700/500 can read the data from the
EL-900/90/87 Voice Disk.
Any one of the voice sections can be
used here. Make sure that the volumes
of all other voices are set to off (the
minimum value).
PAGE
Pressing these buttons steps through the
voice numbers; the name of each voice
appears on the display as well. Refer to the
list included with your Voice Disk for voice
numbers and names.
PAGE
115
NOTE:
NOTE:
8