Table of Contents
Advertisement
THROTTLE LINKAGE AND ENGINE MOUNTING
● Mount the throttle arm to
the carburetor's throttle
shaft as shown in the
diagram or use the throttle
valve stopper plate located
at opposite side.
● Mount the engine as shown
in the diagram.
Gloves
10cm
Tightening torque:
90kg-cm
(8.8 N-m)
Stopper screw
Throttle arm
(not supplied)
CG line
9kg
● For propeller mounting, use the
wrench provided and make sure
not to over-tighten the bolts.
Shaft diameter: 4mm
M4 bolt x4
CG line
Engine mount
Fuselage bulkhead (firewall):
8mm or more, with hard board
Claw nut x4
9
Advertisement
Table of Contents
