Sherwood R-672 Operating Instructions Manual page 51

R-672(A) 2007.6.15 10:17 AM 페이지 51
Continued
When selecting the DOLBY PLII MUSIC
• You can adjust the various surround parameters for optimum surround effect.
Note: The parameter settings are valid only when listening in either Dolby Pro Logic II Music mode or the Dolby Pro Logic IIx
Music mode.
1.
Press the CURSOR UP(▲)/DOWN(▼) buttons to select the "PLII MSC", then press the ENTER button.
2.
Press the CURSOR UP(▲)/DOWN(▼) buttons to select the desired parameter.
3.
Press the CURSOR LEFT(◀)/ RIGHT(▶) buttons to adjust the selected parameter as desired.
4.
Repeat the above steps 2 and 3 to adjust other parameters.
• Each time the CURSOR UP(▲)/DOWN(▼) buttons are pressed,
"PANO" (Panorama), "C.WIDTH" (Center width) or "DIMEN"
(Dimension) is selected.
When selecting the "PANO" (Panorama) mode
This mode extends the front stereo image to include the surround
speakers for an exciting "wraparound" effect with side wall imaging.
Select "OFF" or "ON"(default value:OFF).
When selecting the "C. WIDTH" (Center width) control
This adjusts the center image so it may be heard only from the
center speaker, only from the left/right speakers as a phantom
image, or from all three front speakers to varying degrees.
The control can be set in 8 steps from 0 to 7(default value : 3).
When selecting the "DIMEN" (Dimension) control
This gradually adjusts the soundfield either towards the front or
towards the rear. The control can be set in 7 steps from -3 to
+3(default value : 0).
51