Sherwood R-672 Operating Instructions Manual page 21

R-672(A) 2007.6.15 10:17 AM 페이지 21
Continued
To cancel the surround mode for stereo operation
2CH downmix mode
• This mode allows the multi-channel signals encoded in DTS or Dolby Digital format to be mixed down into 2 front channels and
to be reproduced through only two front speakers or through headphones.
• When the SPEAKER button is set to off to listen with headphones, if the STEREO button is pressed while playing the multi-
channel digital signals from DTS or Dolby Digital sources, it will enter the 2CH downmix mode automatically.
• To cancel the 2CH downmix mode, select the desired Dolby Headphone mode with using the MULTI CONTROL knob on the
front panel or the SURROUND MODE UP/DOWN ( >/< ) buttons on the remote control.
Listening in a Dolby Headphone mode
• The Dolby Headphone function simulates 5.1 channel surround sound, which allows you to enjoy 5.1 channel surround sound
through 2 channel headphones, just like listening from 5.1 channel speakers.
Notes :
• Only when the SPEAKER button is set to off, the Dolby Headphone mode can be selected.
• When playing the 96 kHz PCM(2 channel) digital signals, only the stereo mode can be selected.
• While listening with headphones, select the desired Dolby Headphone mode.
When adjusting the sound parameters
• While playing digital signals from Dolby Digital or DTS program source or listening in a surround mode such as Dolby Pro
Logic II / Dolby Pro Logic IIx Music, Dolby Headphone, Dolby Virtual Speaker mode, you can adjust their parameters for
optimum surround effect.
1.
Press the SOUND PARAMETER button.
• Depending on the signal format which is being input, either the stereo
mode or the 2CH downmix mode is selected.
• To cancel either the stereo mode or the 2CH downmix mode, select
the surround mode with using the MULTI CONTROL knob on the front
panel or the SURROUND MODE UP/DOWN ( >/< ) buttons on the
remote control.
• Each time the MULTI CONTROL knob is rotated or the SURROUND
MODE UP/DOWN ( >/< ) buttons are pressed, the mode changes as
follows :
DH 1 : This simulates the soundfield as if you were in a relatively small room
with less reverberations.
DH 2 : This simulates the soundfield as if you were in a typical listening room
with moderate reverberations.
DH 3 : This simulates the soundfield as if you were in a large space like
theater.
• Depending on the kind of digital input signal or/and the selected
surround mode, the corresponding parameter mode is displayed
for several seconds as follows:
* "NIGHT" (Night mode) :
Selectable only while playing digital signals from Dolby Digital or DTS
source.
* "PANO" (Panorama mode) :
Selectable only while listening in Dolby Pro Logic II/Dolby Pro Logic IIx
Music mode.
* "REF" or "WIDE" (Dolby VS Reference/Wide mode) :
Selectable only while listening in Dolby Virtual Speaker mode.
* "DH 1" (Dolby Headphone 1 mode) :
Selectable only while listening in Dolby Headphone mode.
• If the parameter mode disappears, press this button again.
21