Table of Contents
Advertisement
Vitodens 200-W B2HA/B2HB, 222-F B2TA/B2TB Operating
Menu
(continued)ww
Standard menu (continued)
Note: If your heating system has 2 or 3 heating circuits:
You can select the heating circuit "HC1", "HC2"
or "HC3" to be displayed in the standard menu
(see page 10).
- If your heating system only has one heating circuit:
No heating circuit name "HC..." is shown in the
header.
In the standard menu, you can adjust and scan the most
frequently used settings for the heating circuit shown in
the header:
H Set room temperature
Press the following keys:
for the required value
OK
to confirm
H Heating program
Heating programs:
Standby mode with frost protection monitoring
9
w
Only DHW
w
Heating and DHW
Press the following keys:
for the required heating program
OK
to confirm
Note: For any other connected heating circuits, use the
settings in the extended menu.
Call up the standard menu as follows:
H If the screen saver is active (see page 12): Press any
key except
.
?
H If you are somewhere in the menu: Keep pressing
until the standard menu appears.
Note: 2 minutes after any setting has been made, the
display automatically reverts to the standard
menu.
Symbols on the display
These symbols are not always displayed, but appear
subject to the system version and the operating state.
Heating programs:
9
Standby mode with frost protection monitoring
w
Only DHW
w
Heating and DHW
s
Central heating with standard temperature
m
Central heating with reduced temperature
M
Party mode enabled
N
Economy mode enabled
In conjunction with a solar thermal system:
Solar circuit pump running
A
Burner in operation
Displays
HC1 (2, 3) To display the heating circuit selected
in the standard menu. To change this,
(see page 16).
e
Frost protection monitoring
Messages
Service message
Fault message
Extended menu
In the extended menu, you can adjust and scan the
settings from the control unit's range of functions used
less frequently, e.g. time programs and holiday programs.
The menu overview can be found on page 38.
Call up the extended menu as follows:
H If the screen saver is active: Press any key except
and then press
.
H If you are somewhere in the menu: Press
Controls
?
.
11
Advertisement
Table of Contents
