5-Tone Signaling (Nx-200/ Nx-300 Only) - Kenwood NEXEDGE NX-200S Instruction Manual

5-TONE SIGNALING (NX-200/ NX-300 ONLY)

5-tone Signaling is enabled or disabled by your dealer. This
the 5 tones programmed in your transceiver. Transceivers that
SELCALL (SELECTIVE CALLING)
A Selcall is a voice call to a station or group of stations.
Transmitting
1 Select your desired zone and channel.
2 Press the key programmed as Selcall, Selcall + Status
or Selcall + SDM to enter Selcall mode.
3 Press
• On keypad models, you can directly enter the station ID.
4 Press the key programmed as Call 1 to Call 6 and
begin your conversation.
Note: Additionally, you can also use the keys programmed as Digit
1x Down, Digit 1x Up, Digit 10x Down, and Digit 10x Up keys to
the Selcall number by 1 each time the key is pressed. Digit 10x
Up/Down
the key is pressed.
Receiving
When you receive a call containing the correct tones, the
and the calling station's ID appear on the display. Press any
key to return to normal operation.
Digit 1x Up/Down