DeWalt XR Li-Ion DCL050-XE Instruction Manual page 9

FIG. 2
B
C
F
A
E
OPERATION
WARNING: To reduce the risk of serious personal injury, turn the worklight off
and disconnect the battery pack before making any adjustments or removing/
installing attachments or accessories. An accidental start-up can cause injury.
Installing and Removing the Battery Pack (Fig. 3)
WARNING: To reduce the risk of injury, never depress the battery release button
without removing the battery pack. Depressing the battery release button without
removing the battery pack can result in the battery pack falling out unexpectedly.
NOTE: For best results, make sure your battery pack is fully charged. The worklight
will shut off without warning when the battery is fully discharged.
G
To install the battery pack (D) into the tool handle, align the battery pack with the
H
rails inside the tool's handle and slide it into the handle until the battery pack is firmly
seated in the tool and ensure that it does not disengage.
To remove the battery pack from the tool, press the release button (E) and firmly pull
the battery pack out of the tool handle. Insert it into the charger as described in the
charger section of this manual.
FUEL GAUGE BATTERY PACKS (FIG. 4)
Some D
fuel gauge which consists of three green
D
LED lights that indicate the level of charge
remaining in the battery pack.
To actuate the fuel gauge, press and hold
the fuel gauge button (I). A combination of
the three green LED lights will illuminate
designating the level of charge left. When
the level of charge in the battery is below the usable limit, the fuel gauge will not
illuminate and the battery will need to be recharged.
7
FIG. 3
E
FIG. 4
WALT battery packs include a
E
I