Table of Contents
Advertisement
NOTE: The fuel gauge is only an indication of the charge left on the battery pack.
It does not indicate tool functionality and is subject to variation based on product
components, temperature and end-user application.
For more information regarding fuel gauge battery packs, please contact Stanley Black
& Decker, 82 Taryn Drive, Epping, VIC 3076 Australia or call 1800 338 002 or (NZ)
0800 339 258.
Switch (Fig. 2)
The worklight has a high beam and low beam setting. Press the switch (A) once for high
beam, twice for low beam, and a third time to turn the worklight off.
Pivoting Head (Fig. 2)
The pivoting head rotates in nine positions ranging from 0°–144°.
Carrying and Suspending the Worklight (Fig. 2, 5)
CAUTION: When the worklight hangs by the belt hook or hang hook, do not shake
the worklight or the object from which it hangs. Do not hang the worklight from any
electrical wires or anything that is not secure. Personal injury or property damage
may occur.
CAUTION: Only use the belt hook or the hang hook for hanging the LED worklight.
The belt hook and hang hook are not intended to support additional weight. Do not
attach or hang anything additional to the worklight or risk of breakage may occur.
CAUTION: Do not use the belt hook or hang hook to reach with or to support your
weight in any situation.
FIG. 5
B
HANG HOOK (FIG. 5)
The telescopic hang hook (b) extends out of the pivoting head (c). The hang hook
locks into place when fully collapsed or when fully extended, as shown in Figure 4.
The hook rotates 360 degrees.
BELT HOOK (OPTIONAL ACCESSORY) (FIG. 2)
WARNING: To reduce the risk of serious personal injury, ensure the screw
holding the belt hook is secure.
IMPORTANT: When attaching or replacing the belt hook (H), use only the screw (G)
that is provided. Be sure to securely tighten screw.
The belt hook (H) can be be attached to either side of the worklight using only the
screw (G) provided, to accommodate left- or right-handed users. If the hook is not
desired at all, it can be removed from the worklight.
To move belt hook, remove the screw (G) that holds the belt hook in place, then
reassemble on the opposite side. Be sure to securely tighten screw.
MAINTENANCE
WARNING: To reduce the risk of serious personal injury, turn the worklight off
and disconnect the battery pack before making any adjustments or removing/
installing attachments or accessories. An accidental start-up can cause injury.
Cleaning
WARNING: Never use solvents or other harsh chemicals for cleaning the
non-metallic parts of the tool. These chemicals may weaken the plastic materials
used in these parts. Use a cloth dampened only with water and mild soap. Never let
any liquid get inside the tool; never immerse any part of the tool into a liquid.
CHARGER CLEANING INSTRUCTIONS
WARNING: Shock hazard. Disconnect the charger from the AC outlet before
cleaning. Dirt and grease may be removed from the exterior of the charger using a
cloth or soft non-metallic brush. Do not use water or any cleaning solutions.
Repairs
This charger and battery pack are not serviceable. Servicing at an authorized service
centre is required to avoid damage to static sensitive internal components.
To assure product SAFETY and RELIABILITY, repairs, maintenance and adjustment
8
Advertisement
Table of Contents
