Other Speaker Setup Options; Attaching To A Wall; Fitting Speaker Stands (Optional) - Panasonic SC-HT800V Operating Instructions Manual

Other speaker setup options

Attaching to a wall

[Note]
The wall or pillar on which the speakers are to be attached should be capable of supporting 10 k g (22 Ib.) per screw.
1
Remove the stand. (SC-HT810V only)
BEFORE REMOVING THE STAND
≥Take the speaker cable out of the stand's hole if it is
threaded through.
≥Lay the speaker on a soft cloth.
Unscrew the screw with a Phillips-head screwdriver.

Fitting speaker stands (optional)

Preparation
≥Remove the stand (SC-HT810V only ➡ step 1 above).
≥Ensure the stands meet these conditions before purchasing them.
–Observe the diameter and length of the screws and the distance
between screws as shown in the diagram.
–The stands must be able to support over 10 k g (22 lb.).
–The stands must be stable even if the speakers are in a high
position.
RQT6951
52
Stand
2
Screw a screw (not included) into the
wall.
q–1
30–35 mm (1 3 /
16
‰7.5–9.4 mm (
19 /
q– q)
8–11 mm ( 3 / 7 /
8 16
Wall
3
Fit the speaker securely onto the
screw with the hole or holes.
Vertical
13
5 mm ( /
Attach the stands Plate thickness plus 7 to 10 mm
q to
with these holes. (plus 9 /
32
q)
3 /
8
q– q)
3 /
64 8
Horizontal
100 mm
q)
(3 15 /
16
q), pitch 0.8 mm ( q)
1
/
64 32
q)
60 mm (2 23 /
64
Speaker stand
(not included)
q)
25 /
64