BASIC PROGRAMMING
To prevent possible SEVERE INJURY or DEATH:
• Install a LiftMaster Monitored Entrapment Protection (LMEP)
device.
• NEVER permit children to operate or play with door control
push buttons or remote controls.
MODE
B2
B2 with TTC
C2
REMOTE CONTROLS
Built in 315 MHz radio receiver permits as many as 20 Security✚
SINGLE BUTTON REMOTE CONTROL
1
Repeat steps 1 and 2 for additional remote controls.
3-BUTTON REMOTE CONTROL TO OPERATE AS A WIRELESS 3-BUTTON CONTROL STATION
NOTE: The feature will use 3 of the 20 memory channels in the operator.
1
Repeat steps 1 through 3 to program additional buttons.
TO ERASE ALL REMOTE CONTROLS
1
RADIO OPERATION
OPEN
CLOSE
X
X
X (3-button remote)
X
AVERTISSEMENT
Press and hold the button on the remote control until the LED
2
fl ashes rapidly, then release to complete programming (LED
will go out).
Press and release
the LEARN button
(LED will light).
2
Press and hold
the LEARN button
(LED will light).
PRECAUCIÓN
Press and hold the
LEARN button (over
5 seconds) until the
LED goes out. All
programmed remote
controls will be
erased.
WARNING
WARNING
• Activate door ONLY when it can be seen clearly, is properly
CAUTION
adjusted and there are no obstructions to door travel.
• ALWAYS keep door in sight until completely closed. NEVER
permit anyone to cross the path of closing door.
STOP
X
X
X
X
ATTENTION
®
remote controls or dip switch remote controls in any combination.
ADVERTENCIA
Press the desired
button on the logic
board (OPEN,
CLOSE or STOP).
Release both
buttons.
4
REVERSE WHILE
TTC RESET
CLOSING
X
X
X when open
X
3
Press and hold the desired button of the remote
control until LED fl ashes rapidly, then release.
AVE
AV
AD
A