Table of Contents
Advertisement
Remote Trunk Release
If your system was installed with the Remote Trunk Release option, you can open your trunk by
pressing the
button until the remote displays the text "TRUNK" on the screen. In addition, this
will also disarm the alarm.
Idle Mode
Convenience feature: Idle Mode allows you to keep the engine running and the doors
locked while you stop, for example, at a convenience store or for a short delivery. (remove
this part for IG)
This feature allows you to let the remote starter take over control of the vehicle (i.e. no Key in the
Ignition Switch) while the engine is running.
If your vehicle has an automatic transmission, proceed as follows to set the system to Idle Mode:
1.
With the engine running, make sure to release the brake pedal and press the
or
button on the transmitter until the parking lights come ON.
2.
Remove the ignition key from the ignition switch.
The engine will continue running.
3.
Exit the vehicle and close all doors, hood and trunk.
4.
Press the
If your vehicle has a manual transmission, Idle Mode can be activated through the same routine as
that used for Ready Mode (page-9); at the last step, the
buttons. This will lock the doors, arm the system and leave the engine running.
Note1: The engine will continue running until the user re-enters the vehicle or until the expiration of
the engine run time.
Note2: If the pre-programmed run-time expires or if the user shuts down the engine by remote
control, the vehicle will enter Ready Mode.
Caution!!! Do not leave children or pets unattended in a vehicle standing in Idle Mode.
Valet Modes
When the vehicle is in Combo Valet and Valet Start, the remote starter is disabled. If the vehicle
needs to be serviced, or if you park it indoors, the Combo Valet and Valet Start will prevent the
engine from being remote-started accidentally.
There are 3 sorts of Valet Modes: Combo Valet, Valet Start and Valet Alarm.
•
Combo Valet: Both remote starter and alarm are disabled.
•
Valet Start: Only the starter function is disabled.
•
Valet Alarm: Only the alarm functions are disabled.
1) To put the system into Combo Valet
a)
To put the system into Combo Valet mode using the KEY:
i)
Insert the ignition key into the ignition switch. Within 10 sec., turn the key 5 times
successively into the IGNITION/RUN and OFF positions.
ii)
The parking lights will flash three times.
iii)
Turn the ignition OFF.
iv)
The LED on the antenna will come ON solid to indicate that the vehicle has
successfully entered Combo valet.
v)
The
P. 12
button to lock the doors, to arm the starter kill and to arm the alarm.
icon will appear on your LCD remote.
button is pressed instead of the other
,
User Guide
Advertisement
Table of Contents
