Shelving & Flavor Strip Installation - True TAC-72-LD Installation Manual

True Food Service Equipment, Inc.
SHELVING INSTALLATION / OPERATION
CANTILEVER SHELVING INSTALLATION:
A. Install the shelf supports into the shelf standards that are
located in the rear corners of the cabinet. (See photos 1
& 2).
1
2
SHELF INSTALLATION:
A. Hook shelf clips onto shelf standards. (see shelf Install illustration).
B. Position all four shelf clips equal in distance from the floor for flat
shelves.
Wire shelves are oriented so that cross support bars are facing
down.
C. Place shelves on shelf clips making sure all corners are seated
properly.
NOTE
Do not load product to where it would over hang the shelf.
25
INSTALLATION / OPERATION INSTRUCTIONS
............ www.truemfg.com ............
TAC-72 CANTILEVER SHELVING INSTALLATION:
A. TAC-72 cantilever shelves come packaged inside the
unit. Leg leveling parts may be taped to the top of the
shelf packaging. Remove leg leveling parts. (See photo
3).
B. Remove cantilever shelves from packaging and protective
wrap.
C. Install the shelf supports into the shelf standards that
are located in the rear corners and middle of the cabinet.
(See photo 4).
3
4
(shelf Install Illustration)
Shelf
Standards
Shelf
Shelf
Shelf
Clip
25